Lay out 1 - 2 meters of the stones on the floor. 

 

Arrange the stones in your desired pattern.
 

Apply adhesive to the surface then onto the entire back of each stone and press firmly into place.
 

If the installation includes corners, begin with these and continue the installation in line with the flats. 

 

Any gaps to be filled, all our stones can easily be cut with an angle grinder. 
 

For installations with joins, spacers can be used and then grouted with a grouting gun.
 

For installations over 6m a galvanised steel mesh fixing followed by at substrate primer would need to be applied to the surface pre-installation.

​

Once the stones have been installed and grouted (if the stone requires grout) leave for 48 hours to set then brush off any excess dirt or dust and then apply the mat clear protective stone sealant.